Most growers want to know one thing before they buy a Sumi Soaker: will it run off the garden hose I already have? The answer depends on which tube you're running, how long the tube is, and how big and long your hose is. This guide gives you the quick answer first, then shows you how to check your own supply in two minutes with a bucket.
The Quick Answer
| Tube and length | Will a garden hose run it? |
|---|---|
| Mark II, any length up to 100 ft | Any hose diameter, up to 100 ft long, works. Nothing else to check. |
| R-Wide 25 ft | Any 5/8" or 3/4" hose up to 100 ft. A 1/2" hose works up to about 50 ft. |
| R-Wide 50 ft | A 3/4" hose of any length up to 100 ft. A 5/8" hose up to about 50 ft. |
| R-Wide 100 ft | Depends on both hose length and diameter. See the table below. |
The Mark II needs very little water: about 3.6 gallons per minute (GPM) for a 100-foot run. The R-Wide throws a much wider spray and needs far more: about 3.2 GPM for 25 feet, 6.4 GPM for 50 feet and 12.7 GPM for 100 feet. The longer the R-Wide run, the more your hose matters.
Can Your Hose Run a 100-Foot R-Wide?
A full 100-foot R-Wide line needs about 12.7 GPM. Here's roughly what common hoses deliver from a healthy spigot at about 50 PSI. "Hose length" is the garden hose from the spigot to the tube, not the length of the Sumi tube.
| Hose diameter | 15 ft hose | 25 ft hose | 50 ft hose | 100 ft hose |
|---|---|---|---|---|
| 3/4" (contractor) | Runs it (about 19 GPM) | Runs it (about 17 GPM) | Tight (about 13 GPM) | Not enough (about 8 GPM) |
| 5/8" (typical) | Runs it (about 16 GPM) | Tight (about 13 GPM) | Not enough (about 9.5 GPM) | Not enough (about 6 GPM) |
| 1/2" (lightweight) | Not enough (about 9 GPM) | Not enough (about 7 GPM) | Not enough (about 5 GPM) | Not enough (about 3 GPM) |
The longest hose that will feed a full 100-foot R-Wide is about 50 feet of 3/4" or 25 feet of 5/8", and both of those are tight. Go shorter or fatter for some margin.
Don't Guess: Measure Your Real Supply
The table assumes a healthy spigot with roughly 50 PSI and 12 GPM or more available at the tap. A hose can only pass what the spigot gives it. On a weak well or a long buried supply line, your real number will be lower, and that's why the bucket test beats any table.
The 5-Gallon Bucket Test
- Hook up the hose you'll actually use, at its full length.
- Turn the spigot on all the way.
- Time how many seconds it takes to fill a 5-gallon bucket.
- Divide 300 by the seconds. That's your flow in GPM.
| Bucket fills in | Your flow | What it runs |
|---|---|---|
| 23 seconds or less | 13 GPM or more | A 100 ft R-Wide line |
| 46 seconds or less | 6.5 GPM or more | A 50 ft R-Wide line |
| 83 seconds or less | 3.6 GPM or more | A 100 ft Mark II line |
If the bucket says you have less than your tube needs, size down regardless of what hose you have. Our Water Supply Check does this math for you and tells you what your supply can run.
The Verdict
- Works on most hoses: Mark II at any length runs on any hose. R-Wide at 25 feet runs on any 5/8" or 3/4" hose, and R-Wide at 50 feet on a 3/4" hose or a 5/8" hose up to about 50 feet.
- Works on a short, fat hose: R-Wide at 100 feet. It runs on a short 3/4" hose (about 50 feet or less) or a short 5/8" hose (about 25 feet or less) with strong pressure. Confirm with the bucket test, because it's tight.
- Go mainline: R-Wide at 100 feet on a long or thin hose. If your hose can't hit 12.7 GPM, feed the tube with a Mainline Connector from a pump or mainline, or split the bed into shorter runs. Our mainline sizing guide walks through the pipe.
Which Garden Hose Connector to Order
The Sumi Soaker Garden Hose Connector comes in two versions. You only need one: pick the one that matches your water pressure.
Without a Regulator
Connects your Sumi tubing straight to a garden hose. Order this one when your supply pressure is already in the tube's range: about 29 PSI or less for R-Wide, or 12 PSI or less for Mark II. It's the right pick on gravity-fed tanks, weak wells, or long hose runs that already drop the pressure.
With a Regulator
A complete unit: the tube connection plus a pressure regulator in one. It steps strong supply pressure down to what the tube needs, about 30 PSI for R-Wide or 12 PSI for Mark II. Order this one when your supply is stronger than the tube, which is most city water at 40 to 60 PSI. The regulator needs at least 35 PSI coming in for R-Wide, or 17 PSI for Mark II.
Not sure which? On normal city water, get the one with the regulator. On gravity or a weak well, get the plain connector.
Frequently Asked Questions
Does the length of the Sumi tube or the length of the hose matter more?
Both. The tube length sets how much water you need. The hose length and diameter set how much water you can deliver. A longer or thinner hose loses more flow to friction before the water ever reaches the tube.
Can I run two Sumi lines off one hose?
Only if your bucket test shows enough flow for both. Two 50-foot R-Wide lines need about 12.8 GPM together, the same as one 100-foot line. Two 100-foot Mark II lines need about 7.2 GPM, which most hoses can handle.
What if my hose can't run the R-Wide I want?
Shorten the run, use a shorter or bigger hose, split the bed into two zones you water one after the other, or switch to the Mark II. If you need long R-Wide runs, plan on a mainline.
Can I print this?
Yes. Download the Sumi Soaker cheat sheet (PDF). Page one is this hose guide; page two is the coverage troubleshooting checklist.
Still not sure? Email hello@moderngrower.co with your hose size, hose length and bucket time, or call 877-850-1555, and we'll tell you what it will run.
Ready to set up Sumi Soaker?
Check your water, plan your beds, then pick the kit that fits. Questions? Email hello@moderngrower.co or call 877-850-1555.



