Spray too narrow? Dry strips at the edges, or a line that sprays well near the hose and weakly at the far end? Almost every time, the tube is fine. Sumi Soaker only sprays as wide as the water reaching it allows, so narrow spray almost always means low flow or low pressure at the tube, not a bad tube.
Work through the checks below in order, and stop when the spray opens up.
Start Here: Which Are You Seeing?
| What you see | What it usually means | Where to start |
|---|---|---|
| Narrow along the whole length | Low flow or pressure at the head of the tube | Steps 1 to 5 |
| Narrow only at the far end | The run is longer than your supply can feed | Step 6 |
| Full width, but the soil is still dry | Not a spray problem; it's watering depth | The last section |
The 6-Step Check for Narrow Spray
Step 1: Measure It Right
R-Wide's full spray width is 33 feet in total, which is about 16 feet on each side of the tube. Mark II's is about 13 feet in total, or 6.5 feet per side. Make sure you're comparing the same thing: one side or across both? And is it narrow everywhere, or only at the far end?
If you're getting about 16 feet per side on an R-Wide, that's full performance and nothing is wrong. If it's narrow at the far end only, skip to Step 6.
Step 2: Bucket-Test Your Flow
Time how long a 5-gallon bucket takes to fill from your hose or supply line, with the water on all the way. Divide 300 by the seconds to get gallons per minute (GPM). Then compare it with what your run needs:
| Run | Flow needed |
|---|---|
| R-Wide 100 ft | 12.7 GPM |
| R-Wide 50 ft | 6.4 GPM |
| R-Wide 25 ft | 3.2 GPM |
| Mark II 100 ft | 3.6 GPM or less |
If your flow is below what the run needs, you're flow-limited. Shorten the run, use a bigger or shorter hose, split the bed into two zones, or switch to the Mark II. Our garden hose guide shows what common hoses can deliver.
Step 3: Clean the Filter
A clogged 80-mesh screen quietly chokes flow, and it's the single most common cause of narrow spray. Pull the filter and rinse it out, then reinstall it and test again. If the spray opens back up, clean the filter on a regular schedule.
Step 4: Try It Without the Regulator
The pressure regulator needs a minimum pressure coming in to work: 35 PSI for R-Wide or 17 PSI for Mark II. If your supply is below that, the regulator chokes the flow instead of helping. Remove the regulator, connect the tube directly to the hose, and test again. If the spray gets wider, your supply was already in the tube's range, so run it without the regulator.
Step 5: Check Your Supply Pressure With a Gauge
Thread an inexpensive hose-bib pressure gauge onto the spigot with the water on. These gauges block flow, so they read static pressure: water on, nothing running. Confirm it clears the regulator's minimum of 35 PSI for R-Wide or 17 PSI for Mark II.
If it's below that minimum, the regulator can't work, so run without it (Step 4). If the static pressure is fine but the spray is still narrow, it's flow, not pressure. The restriction is downstream: a small or long hose, or a dirty filter. Your bucket test in Step 2 is the real reading, because a gauge can't show the pressure drop while water runs.
Step 6: Shorten or Split the Run
Pressure drops along the tube as it sprays. If only the far end is narrow, the run is longer than your supply can carry at full width. Shorten the run, or split it into two shorter zones, each fed from the supply separately. Our System Planner will size the runs for your beds, and the Water Supply Check tells you how long a run your water can feed.
Full Width, but the Soil Is Still Dry?
That's a watering-depth problem, not a coverage problem. The pattern is fine; you're just not putting down enough water. Run a longer timer cycle. At full pressure, R-Wide applies about half an inch of water per hour and Mark II about a fifth of an inch, so deep watering takes time.
If a bucket test also shows low flow, the tube is applying water slowly because it's under-fed. Fix the flow first (Steps 2 to 5), then set your run time.
Other Things That Narrow the Spray
- Wind: the fine spray drifts in a breeze. Water early in the morning or in the evening when it's calm.
- Tall crops or covers: on the ground, the R-Wide's low spray can be blocked by tall crops, row cover or shade cloth on either side. Raise the line on risers, or use the Mark II, whose steeper spray clears taller crops.
Printable Checklist
Keep this in the shed: download the Sumi Soaker cheat sheet (PDF). Page two is this troubleshooting checklist.
Still stuck? Email hello@moderngrower.co with your bucket time, hose size and run length, or call 877-850-1555, and we'll help you find it.
Ready to set up Sumi Soaker?
Check your water, plan your beds, then pick the kit that fits. Questions? Email hello@moderngrower.co or call 877-850-1555.



